A decimal point or indicator light on the front panel will begin flashing, signaling that Auto-Tuning is running.
Thermocouple (K, J, E, T, etc.): Connect positive (+) and negative (-) wires to the sensor input terminals. Keep polarity correct to avoid reverse temperature readings. xta-7000 temperature controller manual
Once the light stops blinking, the process is complete, and the controller is optimized for your specific heater/load. 6. Troubleshooting Error Codes A decimal point or indicator light on the
Moves the cursor left when modifying numbers, allowing rapid value editing. the process is complete
Thermocouple: Connect the positive wire to Terminal 9 and the negative wire to Terminal 10.