Configure sub-interfaces on the router to act as default gateways for each local VLAN subnet. Ensure you match the encapsulation IDs with your active VLAN matrix.
A well-designed IP addressing scheme is the foundation of any network. In the ccna-2v7.0 case study -rev b- , students are often given a single network address (like a /23) that must be subnetted to accommodate multiple LANs and WAN point-to-point links. This is where becomes critical. ccna-2v7.0 case study -rev b-
The following is a step-by-step walkthrough of the CCNA 2 v7.0 case study - Rev B: Configure sub-interfaces on the router to act as
Check if PCs are receiving correct IP addresses via DHCP. Summary Table: Key Configuration Areas (Rev B) Requirement Common Commands STP Rapid PVST+ spanning-tree mode rapid-pvst Port Security Maximum MAC 25 switchport port-security maximum 25 DHCPv4 Exclude 172.25.65.0/28 In the ccna-2v7
For example, to allow a remote router (R2) to reach the LANs behind a central router (R1), an administrator would use the ip route command in global configuration mode. A typical static route statement follows this pattern: